Connect a RTK TOP608BT GNSS receiver to a Linux machine.

Posted by jack wu on

Below diagram showing the data flow of this implementation:

RTK Linux Ntrip

Step by step setup Instructions:

Step 1:
Configure NTRIP for the TOP608BT RTK GNSS Receiver via another Android device. Please refer to this step by step instruction.

Step 2:
Please plug the USB connector of the TOP608BT to a Linux machine. For detail, please refer to this document.

Congratulations! Your RTK GNSS receiver has been successfully set up. The high accuracy location data from the RTK GNSS receiver is ready to use for your applications of the Linux machine.



Share this post

← Older Post