Tech Support by Vendors - Canmore
How to reset the i-gotU GT-120B or GT-600B device?
Posted by jack wu on
If your GT-120B/GT-600B doesn't turn on, cannot be paired via Bluetooth BLE, or exhibits any unusual behavior, you could try resetting the device by following these steps: Download and install the Windows version of the i-gotU software. http://www.mobileaction.com/download/gt.jsp Connect the GT-120/GT-600B device to your Windows computer using a USB cable. Open the i-gotU GPS software. Click on the i-gotu device, then click on the "Configure" button. Select the "Reset" option and press the "Update" button. 4. After resetting the device, you can turn it on again and check if the issue has been fixed.
How to Configure Columbus V-1000 to Log Altitude Data with Vertical Accuracy Up to 1 Meter?
Posted by jack wu on
The V-1000 comes equipped with a BOSCH barometric sensor, widely recognized as the highest-performing sensor in the industry. By utilizing this cutting-edge technology, you can achieve greater vertical accuracy by following the configuration steps outlined below: Press the "Up" button until you see the "Settings" option, then select it. From there, select "Operating Modes" → "GPS Mode". To pre-calibrate the altitude, go to the "Settings" menu and select "Setup" → "Altimeter Cal" → "On". Using the up and down buttons, select the current elevation value, which you should obtain in advance from another source. Enter the value and press the...
Canmore GT-730FL-S, GT-750F GPS Week Number Rollover(WNRO) issue.
Posted by shaojie wu on
If you have Canmore GT-730FL-S, GT-740FL or GT-750F(L) GPS logger, please download the latest Canway software below, which has been fixed for the April 2019 GPS Week Number Rollover(WNRO) issue. Please download the Canway software here.
- Tags: Canmore, GT-730FL-S, GT-750F
Is www.canmore.com.tw website no longer accessible?
Posted by jack wu on
From 2018, the company/brand "Canmore" is operating under TSKY. The new Canmore support website ishttp://www.tsky.com.tw/
- Tags: Canmore
For CanWay software which comes with Canmore GT-740FL, how to fix the problem of trips being broken up into separate tracks (files).
Posted by jack wu on
The following comments were from our customer Marc. Thank you Marc for sharing your experience with other users! The key is to select the right time out for the track separate routes criteria. If it is too long, you reduce it and then download from the device again until you get the tracks you want combined. For the short tracks that are on the device just from turning it on, you just delete those. I have now set it up for 30 minutes, given the time I stop for a break, but there is no need to find the right...