Tech Support by Vendors - STOTON — STOTON
What are the cables' length of GNSS100L and GNSS200L GPS receivers?
Posted by jack wu on
The are same. Both are 150cm.
Where to download the Windows 10 / 11 driver of GNSS100 and GNSS200 receivers?
Posted by jack wu on
The GNSS100 and GNSS200 drivers build in Windows 10 /11. You don't have to install driver. Just plugin and works. In Windows' device manager, it looks similar to the below screenshot. If you want to use Windows Location Sensor, you need to install the driver. You can download the driver from here. After the Windows location sensor driver successfully installed, you should be able to see the "u-blox GNSS Location Sensor" from the device manager. Please refer to the below screenshot.
How to change GNSS200L usb GNSS receiver update rate to 10hz?
Posted by jack wu on
By default, GNSS200L industrial GNSS receiver update rate has been set to 1hz. If you want to change it to 10hz. Please follow the below steps. Pre-request:You might need to install GNSS200L usb driver and ublox u-center software to a computer if it didn't already installed. Please plug in your usb GPS to the computer. Open the u-center software. Select the corresponding com port for the usb GPS. Please make sure the usb GPS is connected to the computer during the below steps. step 1. click the "message view" icon.step 2. expand the UBX tree, and further expand CFG tree....