Tech Support by Vendors - Columbus — p-10pro

Your P-10 Pro / P-1 MicroSD memory can be recognized as an external driver when the device is turned off and plugged into a computer. Usually, for a 4GB - 32GB memory card, it takes 10-30 seconds to be recognized by the computer. If the memory card is larger than 32GB, the time needed will be increased accordingly.  You might need to be a little bit more patient to wait for the external drive to show up.

In the situation of : If you try to downgrade the P-10 pr firmware to a previous version, it will freeze and stop functioning.  To solve the issue, please do the below: 1. Copy and paste the below URL to your web browser's address bar and hit enter.  https://cbgps.com/p10/support_en.htm Download the current version of firmware(P-10.BIN) Columbus website.  2. In the power-off state, connect P-10 Pro with PC via the data cable. Make sure there are no files under the root directory of the MicroSD card. Copy the firmware file”P-10.BIN” to the root directory of the MicroSD card. Disconnect the P-10 Pro...

I am very excited to share another groundbreaking news of Columbus P-10 Pro.  From now on, P-10 pro is not only a GNSS data logger, but also a real time sub-meter (0.5m) USB GNSS receiver.  The “receiver mode” is only available for the P-10 pro with V 2.0  and above firmware. If the firmware version of your P-10 pro is lower than that, you could follow the link below to update the firmware. http://cbgps.com/p10/firmware/index_en.html We have tested a P-10 pro in our lab and confirmed it works great with Windows 10, Windows 11, Android and Linux devices as an USB...

For firmware update instructions, please refer tohttp://cbgps.com/p10/firmware/index_en.html Below are factory reset instructions. 1. Unplug the MicroSD card. 2. Press and hold the POI & Function button, then press the power button(Press the three buttons at the same time). Hold pressing for about 5 seconds. Release pressing until the status lamp lights green. 3. You can hear a long beep after about 13 seconds.(Please notice that it should not take over 20 seconds to wait for the beep.)

For background info of 5Hz Columbus P-10 Pro, please refer to our previous blog post here. (optional)   Config the 5Hz log mode Download the 5Hz config.txt file from here.  Turn off P-10 Pro. Connect P-10 Pro to the computer with the cable, copy the downloaded configuration file “config.txt” under the root directory of the MicroSD card, and eject the device. In the power-off state, press the "Power Button" and the "POI Button “simultaneously until you hear 3 short beeps, then the 3 lamps will flash three times at the same time, and finally you hear one long beep, indicating...